Advanced Syringe Pump

PHM-111-EC
Advanced Syringe Pump with Computer Control
(Precise Control of Infusion Rate - Computer Control)

Med Associates, Inc is pleased to announce our latest development in syringe pumps. The PHM-111EC is controlled by an internal computer so that exact infusion rates can be set. Front panel switches allow for a simple setup, thus avoiding complicated menus or charts. All the settings are shown on the LCD display. All these new features come with the proven reliability of the classic Razel™ Pump Mechanism.

Features
• Precision Infusion Rate Control
• Rates Shown On LCD Display
• Select Syringe Type and Capacity
• Proven Pump Mechanism (Tens of Thousands In Use)
• Computer Control from MED-PC^®
• Stainless Steel Used For All Critical Parts

Infusion Rates
.145 to 430 ml/hr . . . . .with 50ml syringe
.095 to 282 ml/hr . . . . .with 30ml syringe
.071 to 210 ml/hr . . . . .with 20ml syringe
.040 to 117 ml/hr . . . . .with 10ml syringe
.025 to 75 ml/hr . . . . . .with 5ml syringe


LCD Display:	Displays Selected Syringe Manufacturer, Capacity and Infusion Rate.
Run/Stop:	Stop allows new parameters to be set. Run activates the pump.
Syringe Brand:	Factory direct support for many syringes from the following manufacturers: Becton, Dickinson & Co. (BD) Plastipak, Monoject, BD Glass, Terumo, Unimetrics, Hamilton (µl), Hamilton (ml), and Popper & Sons. Alternatively, you can enter custom syringe sizes.
Capacity:	Depends on brand. Value displayed in LCD display.
Infusion Rate:	Sets the Infusion Rate.
Out of Range Indicator:	Indicates when the infusion rate is out of range.

MED-PC^® Computer Control Via USB or Standard MED Outputs

The software controls up to 16 pumps.
Each pump reads its own ID from the switch settings on power up. This makes it easy to change pumps without setting internal jumpers, swapping cables, or changing computer connections.
Commands available:
- Simple On, Off, & Reverse commands sends the data with the command once, the pump does the rest.
- The pump starts then stops after the exact dose is delivered using the Dose command.
- Two Ramp commands are available, the pump either stops or keeps running when the Ramp Time expires.
- Read Status command returns extensive diagnostic data including a high resolution pump travel counter
  and a 20 millisecond timer counter.
- The Reset command clears the timer & travel counters.
- The Set Alarm command permanently sets Loud or Low volume and the limit switch alarm repeat rate.
The PHM-111 pump executes the Dose & Ramp commands using it’s own internal timing. The PC is not burdened with strict timing functions.
The software error status indicates sumless, pump data out of range, or pump not connected. Eliminates trial & error checking when an error omlurs.

< back to top>

Back to Main

Site Updated: July 1, 2008